Hatco GR-B Manuel D'installation Et D'utilisation page 10

INSTALLATION
NOTICE
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
NOTE: Unit must be transported in the upright position.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit and any accessories.
NOTICE
Do not lay unit on the side with the control panel. Damage
to unit could occur.
Assembly
GR-B Model
Model GR-B is preassembled. Follow unpacking instructions
before operating unit.
GRFF, GRFFL, UGFF, and UGFFL Models
NOTE: A Phillips Screwdriver is required for this assembly.
1. Remove top housing, leg brackets, and base unit from
carton and set parts on a non-scratch surface.
2. Remove all packaging materials from unit.
3. Position the top housing, element side up, on a non-
scratch surface.
4. Using the four screws provided attach both leg brackets to
the top housing.
Top Housing
Screw
Assembly of Top Housing and Leg Bracket
Leg Bracket
10
5. Secure top assembly to base unit using the four sets of
lock washers and wing nuts provided.
Washer
Lock Washer
Wing Nut
Assembly of Top Housing/Leg Brackets to Base Unit
6. Place unit in desired location.
GRFFB, GRFFBL, UGFFB, and UGFFBL Models
1. Remove Portable Foodwarmer from carton and set pre-
assembled unit upright.
2. Remove all packaging materials from unit.
3. Insert chrome pan rail open end first.
4. Push adjacent end down firmly so the chrome pan rail
rests on top of base unit.
Pan Rail
Assembly of Chrome Pan Rail
5. Place unit in desired location.
NOTE: When transporting Portable Foodwarmers, always allow
unit to cool down before moving it. Be sure to support
top housing and base unit together.
English
Form No. GRPM-1020