EINHELL LE-SS 150 Mode D'emploi page 5

Anleitung LE-SS 150 SPK1
Wear goggles!
Wear a breathing mask!
22.09.2005 11:40 Uhr Seite 5
Always keep the dust extraction holes
in the vibrating plate free of dirt or
other obstructions.
Vibration measured according ISO
5349.
Special acessories
Sandpaper
Grain Packed in Art. no.
units of
40, coarse 10
60, medium 10
100, fine 10
In order to take full advantage of your
vibrating grinder, always use original
Einhell special accessories, available
at all hardware shops.
Attaching sandpaper
– Remove the plug from the mains
supply.
– Insert the end of the sandpaper and
close the clamping mechanism.
– Draw the sandpaper tigth over the
vibrating plate and clamp the other
end.
– Ensure that the holes match with the
vibrating plate.
Maintenance
– Always keep your vibrating grinder
clean.
– Do not use caustic cleaning agents
to clean the plastic housing.
– Check the carbon brushes is an
excessive amount of sparks is gene-
rated when working.
– Always keep the dust extraction
holes in the vibrating plate free of
dirt or other obstructions.
– Water must never come into contact
with the machine.
Ordering replacement parts
Please quote the following data when
ordering replacement parts:
Type of machine
Article number of the machine
Identification number of the
machine
Replacement part number of
the part required
For our latest prices and information
please go to www.isc-gmbh.info
GB
44.602.00
44.602.01
44.602.02
5