4.
To be performed exclusively by authorised technical service!
In order to replace these components, it is important to first do the following:
- Shut off the gas supply outlet valve
- Remove the grease well drawer (T Fig. 3)
- Disassemble the front panel with the knob (Fig. 3 positions P and K)
- Remove the drawer guide.
A) Safety Valve knob (N Fig. 2)
- Unscrew the gas inlet (5) and outlet (7) connections with a size-19 spanner
- Unscrew the pilot burner inlet (4) with a size-10 spanner
- Unscrew the thermocouple (6) with a size-9 spanner
- Install the new safety valve knob
- Check the idle screw (bypass) (B); it should comply with Table II.
ATTENTION: check the gas sealing.
B) Thermocouple (Fig. 1 and 2)
- Unscrew the thermocouple of the safety valve (6 Fig. 2) with a size-9 spanner
- Unscrew the nut (1 Fig. 1) with a size-10 spanner
- Install the new thermocouple.
C) Spark plug (Fig. 1)
- Detach the high-voltage wire from the spark plug (6)
- Unscrew the nut (9) with a size-10 spanner
- Install the new spark plug
- Connect the high-voltage wire.
D) Piezoelectric Igniter (Fig. 3)
- Detach the high-voltage wire from the igniter
- Unscrew the nut behind the panel (7)
- Install the new piezoelectric igniter
- Mount back the grease well drawer
- Mount back the front panel and the knob (K and P Fig. 3)
- Replace the grease well drawer (T Fig. 3)
5.
5.1
LAVASTONE GRILL USE INSTRUCTIONS
1) Structure
2) Gas burner
3) Brazier with splash-guard
4) Lavastone support grid
5) Lavastone
6) Meat grid
7) Fish grid
See picture for correct lavastone grill montage.
Attention! For first lavastone grill working, remove the lavastone from bag
and put it on the support grid (4), excluding small pieces and fragments;
then distribute the lavastone uniformly in order to cover the grid completely.
5.2
IGNITING THE PILOT BURNER FIG. 2 AND 3
WARNING: Before turning the machine on, make sure the stone is well
distributed on the grill. The maximum quantity allowed is equal to 8 kg,
such as the bag supplied with the machine.
- To ignite the pilot burner, press the knob (P) turning it to the left to reach
the symbol (
); having reached this position, press the knob deeply
down and at the same time push the piezoelectric ignition button (Z).
GB
REPLACING IMPORTANT COMPONENTS
INSTRUCTIONS TO USER
- 18 -