Skytec TEC6200 Mode D'emploi page 3

OPERATION
1. Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the amplifier.
2. Connect output from mixer ( or any other suitable signal source) to the appropriate input sockets of the power amplifier.
NOTE. All inputs are UNBALANCED and connections for the XLR input are Pin 1 = Gnd, 2=+IN, 3= Gnd.
3. Connect the power cord to the mains.
4. Turn gain controls to minimum , switch on the amplifier and the red power LED will illuminate.
5. Adjust gain controls to required level. NOTE. If the audio input signal is too high, distortion will result and the CLIP indicator will light.
If the clip LED is lit permanently or flashes, the gain level should be reduced.
6. Protect LED. These power amplifiers feature a unique short circuit relay protection system. When the output is shorted the amplifier
will go into protect mode with the yellow LED illuminating. Switch OFF the unit and remove the short circuit. Switch ON the amplifier
and the output will be returned immediately.
For reliable and trouble free operation, please observe the following points:
• Ensure all input / output connections are correct and secure.
• The handling capacity of the loudspeakers is adequate for the output of the amplifier.
• Always site the amplifier in a well ventilated location
• Protect unit from severe shocks
Stereo output power RMS @ 0.1% THD
Maximum output power
Single channel driven 4Ω load
Load impedance minimum
Input connectors
Output connectors
Input sensitivity
Input impedance
Frequency response
THD +N
Signal to noise ratio
Cross-talk
Protection
Indicators
Cooling
Mains power
Power consumption
Fuses AC mains
DC
Dimensions (WxDxH)
Weight
TEC6200 TEC6300
2 x 100W 2 x 150W
2 x 200W 2 x 300W
110W 165W
4Ω
RCA phono socket
1/4" (6.3mm) jack socket
(mono)
1/4" (6.3mm) jack socket (mono)
775mV
<0.05% @ 1kHz and rated power single channel
Protection against short circuit and DC on output
Power on, CLIP-L, CLIP-R, PROTECT
80mm fan 80mm fan
550VA 750VA
T3.15A T3.15A
T3.15A T3.15A
482 x 88 x 330mm (2U)
10kg 10.3kg
3
TEC6500
2 x 250W
2 x 500W
270W
4Ω 4Ω
Combination XLR/jack
(1=Gnd, 2=+IN, 3=Gnd)
10K
20Hz-20kHz ±3dB
> 90dB
> 50dB @ 1kHz
80mm fan
230V, 50Hz
1100VA
T5A
T5A
10.5kg
TEC6950
2 x 500W
2 x 950W
540W
4Ω
RCA phono socket
(mono)
Speakon (+1 /-1)
4dBBu (1.2V)
10k
80mm fan
2100VA
T10A
T12.5A
482 x 88 x 335mm
14kg