Skytec TEC6200 Mode D'emploi page 2

OPERATION MANUAL - STEREO POWER AMPLIFIERS
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
IMPORTANT
Then wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow: Earth
Blue: Neutral (N)
Brown: Live
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in your plug
proceed as follows:
Front Panel (All models)
POWER
1 2
Rear Panel (TEC6200 and TEC6300)
INPUT
RIGHT LEFT
L
R
1 2 3
Rear Panel (TEC6500)
INPUT
RIGHT LEFT
L
R
1 2 3
Rear Panel (TEC6950)
(E)
(L)
OUTPUT
RIGHT LEFT
4 5
OUTPUT
RIGHT LEFT
4 5
1 2 3 4 5
WARNING: THIS APPLIANCE MUST BE EARTHED
The wire which is coloured green and yellow must be connected to the
terminal which is marked by the letter E or by the safety earth symbol or
coloured green and yellow. The wire which is coloured blue must be
connected to the terminal which is marked with the letter N or coloured
black. The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured Red. If a 13Amp (BS1363) plug
or any other type of plug is used, a 5 Amp fuse must be fitted either in the
plug or at the distribution board.
CLIP PROTECT CLIP
0 10 0 10
LEFT RIGHT
3 4 5 6 7
6 7
6 7
6
2
1. Power switch
2. Power on/off LED indicator
3. LH channel gain control
4. LH clip indicator
5. Protect indicator
6. RH clip indicator
7. RH channel gain control.
1. RH channel input ( 6.3mm mono socket)
2. R + L inputs ( RCA phono sockets)
3. LH channel input ( 6.3mm mono socket)
4. RH channel output ( 6.3mm mono socket)
5. LH channel output ( 6.3mm mono socket)
6. Fuse holder
7. Mains input power socket
1. RH channel input (Combination XLR
/6.3mm socket, unbalanced)
2. L+R channel inputs (RCA phono sockets)
3. LH channel input (Combination XLR /
6.3mm socket, unbalanced)
4. RH channel output (Speakon connector)
5. LH channel output (Speakon connector)
6. Fuse holder
7. Mains input power socket
1. RH channel input (Combination XLR
/6.3mm socket, unbalanced)
2. L+R channel inputs (RCA phono sockets)
3. LH channel input (Combination XLR /
6.3mm socket, unbalanced)
4. RH channel output (Speakon connector)
5. LH channel output (Speakon connector)
6. Mains input socket and fuse.
GB