Air Purification - Bosch PAM0520 Mode D'emploi

Place a bowl at the drainage pipe outlet and
remove the plug to collect the condensed
water, Fig. 21.
Remove the diffusion duct and set the air
expulsion tube to the position shown in .......
fig 22.
The expulsion tube may also be totally
dismantled if desired.
Lift the air director on the top of the
appliance. This air director is not installed
on the appliance on PAM0530 models. See
figures 26 and 27 in "Heating".
Plug the appliance into the mains electricity
supply.
Set the control knob to the dehumidification
function depending on the model of your air-
conditioning appliance.
Models with electric heating
models .
Instructions for Use
Warning!
The amount of water dehumidified may vary
depending on ambient conditions (See
"Technical Information").
Do not forget to replace the plug onto the
water drainage pipe when you change
function, otherwise the appliance will shed
water when operated.
Remember that ambient temperature must
be 18
to work.
Fig. 21
In this operation function, room
temperature rises slightly.

Air purification

The air inside the room (ventilation) is
circulated through a filtering system when the
appliance is set to this function.
The appliance comes with a basic filter
(already fitted on the appliance) and a
purifying filter (except on models PAM0520) to
be fitted by the user-See "Fitting the purifying
filter (double active)"- against:
- Pollen, bacteria and dust.
Put the air expulsion tube in the same
position as for dehumidification.
Fig. 22
Lift the air director on the top of the
appliance. This air director is not installed
on the appliance on PAM0530 models. See
figures 25 and 26 in "Heating".
Plug the appliance into the mains electricity
supply.
Set the control knob to the air-purification
function
; other
Fig. 23
29
0 C or higher in order for the appliance
Fig. 24.
Fig. 24