Dehumidification
Air purification
mode
When set to
, the appliance removes humidity
from the atmosphere. It does not, however, control
the temperature.
Turn drainage stopcock 90° in an anti-clockwise
direction.
Remove stopcock plug and insert drainage pipe.
stored in the main filter compartment.
Place a bowl at the drainage pipe outlet to collect
the condensed water in.
Put the air extraction duct in storage position.
Set control knob to dehumidification position
The amount of water removed from the air can
reach as much as 30 liters/24 hours, depending
on atmospheric conditions.
Warning!
• Do not forget to put the plug back in place on
the drainage stopcock and to turn the
stopcock 90° in a clockwise direction before
setting the appliance to the temperature
control setting. The appliance will shed water
should you fail to do so.
• If the "Dehumidification" light flashes on and
off, then room temperature is lower than 18°C.
Always remember that in order for the
dehumidification function to work properly,
ambient temperature must be at least 18°C.
The air inside a room is circulated through a set of
purifying filters when the appliance is set to this
function.
The appliance comes with a main filter with a
double active purifying filter. This special filter is
for:
- Smells and smoke.
- Pollen, bacteria and dust.
Put the air expulsion duct in the same position
as for dehumidification.
Set purification speed setting:
maximum
We recommend you leave the optional filters in
position regardless of the desired function setting
(cooling, dehumidification, air purification). The
appliance purifies the air more efficiently in this
way.
or silent
.
.
25