Tools Needed For The Assembly; Your 2 Channel Radio System - Carson SUPER ATTACK Mode D'emploi

Tools needed for the assembly

GB
Modelling knife
Philips screwdriver
(small and big)
1,5 / 2 / 2,5 mm

Your 2 channel radio system

Please read the instructions provided with your radio system
before using it.
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Batteries for
receiver
6 V
0 0
3 0
Steering servo
6 CARSON SUPER ATTACK 304010
74053 Instant adhesive
Hexagonal wrench
74023
Receiver
Receiver antenna
Switch
53339 Needle nose pliers
13118 Tool kit
Transmitter
Engine throttle
servo
74034 Scissors
908046 Side cutter
Transmitter antenna
13305
74035