ST SWR 2604 Manuel D'utilisation page 119

12. PROBLEM IDENTIFICATION
PROBLEM
1. No start
2. Power loss.
3. Engine rotates at
the minimum or
operates irregularly
4. Excessive vibrations
5. Loss or slowing of
thrown material
6. Traction not working.
If problems persist after having performed the above operations, contact your dealer.
PROBABLE CAUSE
Ignition switch OFF.
No fuel.
Choke disconnected
Primer bulb not pressed
Engine flooded
Spark plug damaged
Spent fuel
Water in fuel
Too much material thrown
Fuel tank cap dirty or covered
with ice or snow.
The choke is engaged
Spent fuel
Water in fuel
Carburettor needs replacing
Loose or damaged parts or brush.
Handle not correctly positioned.
Brush jammed.
Brush to far from the ground.
Traction drive command cable
not correctly adjusted.
Turn the ignition switch ON.
Fill the tank with quality, pure fuel.
Engage the choke.
Press the primer bulb
Wait a few minutes before starting.
Do not press the primer bulb
and disconnect the choke.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Reduce speed
Remove dirt, ice or snow from
over and around the tank cap
Disconnect the choke.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Contact the authorised assistance centre.
Tighten all the fastening devices.
Replace the damaged parts in the
authorised assistance centre.
Ensure the handle is fastened in its position.
Remove any dirt or foreign
bodies from the brush.
Adjust small wheel height.
Contact the authorised assistance centre.
EN - 12
REMEDY