ST SWR 2604 Manuel D'utilisation page 110

• Before abandoning the machine, turn
off the engine and all controls.
• Before carrying out repairs, cleaning,
inspections or adjustments, switch
off the engine wait until all moving
parts stop (unless otherwise indicated
in the instructions). Disconnect the
electrical motor wires. (Optional)
• Do not touch the engine parts which
heat up during use. Burns hazard.
• Never operate the machine at high transport
speeds on slippery surfaces. Exercise
caution when reversing. Look behind you
to make sure there are no obstacles before
and during operations in reverse gear.
• Disengage the brush when the machine is
being transported or is not being used.
• Always be sure of your footing, and keep a
firm hold on the handle. Walk, never run!
Use limitations
• Do not use the machine sideways on a
slope. Always move from top to bottom,
then from bottom to top. Exercise
caution when changing direction on
a slope. Avoid steep slopes.
• Do not use the machine if the guards
are insufficient or if the safety devices
are not correctly positioned.
• Never disengage or tamper
with the safety systems.
• Do not alter the engine adjustments, nor
over-run it. If the engine is forced to work
with an excessive number of rotations,
the risk of personal injury increases.
• Do not overload the machine
by driving it too fast.
• Never place your hands inside the
brush protection guard without having
first turned off the engine and waited
until all moving parts have stopped.
2.4 MAINTENANCE, STORAGE
AND TRANSPORT
Ensure regular maintenance and correct
storage to maintain machine safety.
Faulty or worn-out parts must always
be replaced and never repaired. Only
use original spare parts: the use of non-
original and/or incorrectly fitted parts will
compromise the safety of the machine,
may cause accidents or personal injuries
for which the Manufacturer is under no
circumstance liable or responsible.
Maintenance
• If the fuel tank has to be drained,
this should be done outdoors and
when the engine is cool.
• To reduce the risk of fire, regularly check
the machine for oil and/or fuel leaks.
Storage
• Do not leave fuel in the tank if the
machine is stored in a building where
fuel vapours come in contact with the
open flame, sparks or heat sources.
• Let the engine cool down before
storing the machine indoors.
• Always refer to the instructions for use for
important details if the machine needs
to be stored for a long period of time
Transport
• If the machine must be transported
on a truck or trailer, use ramps with
suitable resistance, width and length.
• Load the machine with the engine
switched off and pushed by an
adequate number of people.
• During transport, close the fuel cock (if there
is one) and adequately secure the machine to
the means of transport using cables or chains.
2.5 ENVIRONMENTAL PROTECTION
Safeguarding the environment must be a relevant
and priority aspect of machine use, of benefit to
the community and the environment we live in.
• Avoid being a disturbance to
the neighbourhood.
• Adhere strictly to the local regulations
governing the disposal of packaging, oil,
fuel, filters, damaged parts or any other
element which may have an impact on
the environment; this waste should not be
disposed of along with standard household
waste, but must be disposed of separately
and sent to special waste disposal
facilities for handling and recycling.
• When the machine is withdrawn from service,
do not dump it in the environment, but take
it to a waste disposal facility in accordance
with the local regulations in force.
EN - 3