MBM CPE77T Manuel D'installation Et D'utilisation page 27

Every technical change has
an effect on the operation or
safety of the appliance and
must therefore be performed by te-
chnical personnel of the manufactu-
rer or by technicians who are formal-
ly authorised by the same. Failure to
do so exempts the manufacturer
from any liability for for any possible
resulting modifications or damage.
Upon arrival, check the integri-
ty of the appliance and its com-
ponents (e.g. power cord), pri-
or to use. In the presence of faults
do not start the appliance and con-
tact the nearest service centre.
Read the instructions before
acting.
to be performed. As far as personal
protective equipment is concerned,
the European Community has issued
Directives which the operators must
comply with. Noise ≤ 70 dB.
It is forbidden the installation
of stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the connections
check the technical data shown
on the rating plate of the applian-
ce and the technical data in this ma-
nual. It is strictly forbidden to tamper
with or remove the plates and picto-
grams applied to the equipment.
Disconnect all supplies (e.g.
water - gas - electrical) up-
stream the appliance whenever
you need to work in safe conditions.
Connect the appliance in the se-
quence of the water, then to the
gas network. Ensure there are no
leaks then proceed with the connections
to the mains.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear protective
equipment suitable
for the operations
- 5 -
The appliance is not designed
to work in an explosive atmo-
sphere and as such its installa-
tion and use is categorically prohibi-
ted in such environments.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters of
this manual.
The appliance is not intended for
recessed installation. / The ap-
pliance must be used in a well
ventilated area. / The appliance must
have free drainage (not hindered or
impeded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is con-
nected to the power and drain
sources, it must remain static
(fixed) in the place of use and main-
tenance. Incorrect connection may
cause danger.
Use where appropriate flexible
cable for connection to the
mains electricity supply with
characteristics not inferior to the
type with insulation model H07RN-F.
The supply voltage supported by the
cable with the appliance working
must not differ from the nominal vol-
tage value ± 15% shown at the bot-
tom of the technical data table.
The appliance must be includ-
ed in an "Equipotential" ground
discharge system.
Drainage of the appliance must
be conveyed into the grey wa-
ter discharge network in an
open "glass" unsiphoned formation.
2.
EN