Klarstein CLEARCUBE Mode D'emploi page 21

The ice making cycle lasts about 15 to 20 minutes, depending on the
ambient temperature.
• For the first time, according to the initial water temperature, ice-
making last time will be a little longer.
• In the extreme hot room temperature, ice-making time maybe vary a
3
lot, but it will not exceed 40 minutes.
Note: After plugging on the unit, press "ON/OFF" button for more than 5
seconds, then release to start the unit, the unit will add 3 minutes more
to each ic-making cycle automatically to thicken the ice cube. So if you
desire to thicken your ice-cube, please turn off you unit first, then press
"ON/OFF" button again for more than 5 seconds to turn on the unit again.
While the ice-maker is on, verify the water level of the internal tank
located underneath the ice basket periodically.
• If there is no enough water to last ice-making cycle, the unit will
automatically let the water flow from the big water reservoir
downward to the internal tank to continue the ice-making process.
• If both of the internal water tank and big water reservoir have no
enough water,, the ice maker will stop automatically, and the " REFILL
WATER" indicator will be on.
4
Note: Check to be sure that both of water filter located at bottom of
big water reservoir and internal water tank are not blocked by the dirty
substance or some foreign matter.
• Second to fill water up to big water reservoir to the max. water level
mark.
• After shipping or moving the unit, better to allow the refrigerant
liquid inside the compressor at least 3 minutes to settle before
restarting.
• The ice maker automatically stops working when the ice basket is full
5
and the "REMOVE ICE" indicator will be on.
• Change water in the water reservoir every 24 hours to ensure a
6
reasonable hygiene level. If unit isn't in use for a long time, drain all
water left in the water tank and water reservoir.
EN
21