Klarstein CLEARCUBE Mode D'emploi page 22

EN
22
CLEANING AND CARE
1. Always unplug the ice maker before servicing.
2. Take out the ice basket.
3. Clean the interior with diluted detergent, warm water and a soft cloth.
4. Then use the water to rinse the inside parts, and drain out the water from the
draining port by unplugging the drain cap on the back.
5. The outside of the ice maker should be cleaned regularly with a mild
detergent solution and warm water.
6. Dry the interior and exterior with a soft cloth.
7. When the machine is not in use for a long time, open the water drain cap to
drain water completely out from the water reservoir.
Important notes on cleaning
• After using your ice maker for a long time, we also suggest you should clean
your unit. Especially to the water separator pipe and the wate filters, you must
clean them periodically.
• If the water separator pipe is blocked and there is no water flowing down
when you listen the compressor and the water pump inside are still working,
please turn off the unit first and disassemble this pipe down, and clean it.
• Clean the each hole on the pipe wall displayed in following picture. After
cleaning, install back the water separator pipe and be sure the right terminal
of the pipe connect to the silicone pipe well and as original.
Water seperator pipe
Hole
Evaporator