Proper Installation; When Not In Use - Midea MLH52S7AGS Manuel Du Propriétaire

•
If the supply cord is damaged, it must be replaced by the
manufacture, its service agent or similarly qualified persons in order
to avoid a hazard.
•
The new hose-sets bought from the retailer where the product was
purchased are to be used and that old hose-sets should not be
reused.
•
This appliance is for indoor use only.

PROPER INSTALLATION

•
This washer must be properly installed and located in accordance
with the Installation Instructions before it is used. Ensure the cold
water hose is connected to the "C" valve.
•
Install or store where it will not be exposed to temperatures below
freezing or exposed to the weather, which could cause permanent
damage and invalidate the warranty.
Properly ground washer to conform with all governing codes and
ordinances. Follow details in installation instructions.
WARNING
Electrical Shock Hazard
•
Plug into a grounded 3 prong outlet.
•
Do not remove the ground prong.
•
Do not use an adapter.
•
Do not use an extension cord.
•
Failure to do so can result in death, fire or electrical
shock.

WHEN NOT IN USE

Turn off water faucets to minimize leakage if a break or rupture should
occur. Check the condition of the fill hoses; We recommend changing the
hoses every 5 years.
State of California Proposition 65 Warnings:
WARNING: Cancer and Reproductive Harm
-www.P65Warnings.ca.gov.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY
5