Midea MLH52S7AGS Manuel Du Propriétaire page 18

Delay
Display
Pause/Add a Garment
18
You can delay the start
of a wash cycle for up to
24 hours. Press the Delay
Wash button to choose
the amount of time you
want to delay the start of
the wash cycle. Once the
desired time is reached,
press the Start button. The
machine will count down
and start automatically at
the correct time.
Displays the approximate
time remaining until the
end of the cycle.
NOTE: The cycle time
is affected by the water
pressure in your home and
the balance of the load
in the washer. You may
see the time remaining
on the display increase to
accommodate a slower
spin speed to handle
unbalanced loads.
C B A
D E
Press to start a wash
cycle. If the washer is
running,pressing it once
will pause the washer.
Press again to restart the
wash cycle.
If you want add a
garment,please press the
Start/Pause. The washer
will unlock the door. Press
again to restart the cycle.
NOTE: If you forget to fully
close the door, a remainder
signal will beep reminding
you to do so.
NOTE: If you open the door
when the delay is counting
down, the machine will
enter the pause state. You
must close the door and
press Start again in order
to restart the countdown.
Cycle status is also
displayed and certain
features such as Delay
Wash or Steam are shown
indicating they have been
selected.
a
Display:
Wash Tim e Delay Tim e
Sp eed E rror
E nd Tem p
b
Wi-Fi (on some models)
c
Remain-Delay
d
Control Lock
e
Door Lock
NOTE: In some cycles the
washer will drain first,then
unlock the door when it is
paused.
NOTE: The washer
performs automatic system
checks after pressing the
Start button. Water will
flow in 45 seconds or less.
You may hear the door lock
and unlock before water
flows; this is normal.