Mounting The Box - Astralpool Selwatch Notice D'installation Et D'utilisation

2.

- Mounting the box

2
Mount your device on the wall, preferably protec-
ted from bad weather, and close to the filtration
box in order to facilitate the electrical connections.
Avoid direct exposure to sunlight.
Mounting the wall support
Keep to the following sizes (in mm). They indicate
the obligatory minimum spacing between the sup-
port and other elements on the wall.
80 mm
500 mm
Note :attachment screws and plugs are provided.
Ensure that the holes are ø 8 mm in diameter.
Corrector
tanks: pH-,
pH+ and liquid
chlorine pipe
3,6 and 7
Chamber (see
section 2.4
Connecting the
chamber) pipe 1
and 2
Gravity
evacuation
Water sampling always after the filter
(S t 3-02, 3-06
elwatch ype
only in the absence of the chamber
17
250 mm
100 mm
pH reagent ("RpH" pipe)
3-07) - pipe 2
and
Place the device on the support
Fit the bottom of the device into the grooves on
the wall support and clip the top into place.
Check that the clip is
properly positioned
2. - Hydraulic connection
3
to a traditional filtration system
See above diagram.
Disposal of wastewater
Regarding the disposal of reagents, please refer
to the technical regulations drawn up by your
local sewage department.
Chlorine reagent ("RCL" pipe)
Switch
Digital display (controls
the device's functions)
pH+ or pH- injection option
( S 3-09 ) - pipe 1 and 8
t 3-06, 3-07
elwatch ype and
liquid chlorine injection (S
elwatch
Pressure-relief kit option (see p.10 - Pressure-relief kit option) )
List of pipes
1 . pH- injection
2. Water sampling
3. pH- suction
4. Drains
5. Liquid chlorine
injection
6. pH+ suction
7. Liquid chlorine suction
8. pH+ injection
3-07 ) - pipe 5
t 3-02, 3-06
ype and
Isolation valve
Evacuation
pipe 4