Maintenance - Sievert TW 5000 Mode D'emploi

STOPPING THE MACHINE AND COOLING DOWN
After you have finished welding, press the release
trigger positioned under the nozzle and guide
the nozzle all the way to the right. The drive will
immediately stop when you move the nozzle to the
right. Set the nozzle in a position pointing upwards.
To activate the cooling down sequence simply
push the fan button and wait. Text "Cooling!" will
appear in the display window. The heat is turned off
immediately but the fan will continue to run and will
stop automatically after the temperature has dropped
to a sufficient cool down level.
!
CAUTION! Hot surface; avoid
contact. This cooling process is
necessary to avoid damage to
the heating element.
Wait until the cooling process is finished before you
turn off the power at the main switch.
CHANGING THE HEATING ELEMENT
!
WARNING! To reduce the risk of fire or electric shock, make sure that the TW 5000 hot-air
welding machine is disconnected from the supply circuit before changing the heating element.
▪ Stop the machine as described and remove the plug from designated power source.
WARNING! Touching the element housing and/or nozzle during or after operation could cause
!
burns.
CAUTION! Element housing and/or nozzle have hot surfaces. Allow the hot-air welding machine
to cool down before you exchange the heating element.
GB
OPERATION

MAINTENANCE

- 8 -
1
2
3