Technical Specifications - Sievert TW 5000 Mode D'emploi

PRODUCT DESCRIPTION

TECHNICAL SPECIFICATIONS

Type no.
Voltage
Cable Connection
Power Consumption
Frequency
Temperature, fully adjustable
Drive, fully adjustable
Air flow, fully adjustable
Emission level
Nozzle
Width of welding seam
Dimensions
Weight (4 kg / 8.8 lb built-in weight)
Additional weight (included)
Additional weight (not included)
Power cord length
POWER SUPPLY AND EXTENSION CORDS
CAUTION! To provide continued protection against risk of electric shock, connect to properly
!
grounded outlets only.
CAUTION! To reduce the risk of electric shock, keep extension cord connection dry and off
the ground.
General information for electric supply
The TW 5000 is delivered with power cord: 3 x 2.5 mm²,
earth (ground) is green/yellow; the two other wires are
neutral and phase 1 at single phase connection and
phase 1 and phase 2 at two phase connection.
▪ Use direct supply from main electric distributor or
use a generator.
▪ Use cables with 3 wires. Please note that the earth
(ground) wire is green and yellow.
▪ Recommended diameter of wires minimum 2,5 mm²,
maximum cable length 55 metres. If 1,5 mm² wires
are used, maximum cable length 35 metres.
▪ Use only extension cords with sufficient wire
diameter in accordance with information above.
▪ Your country's specifications of electric tools and
installations should be respected.
GB
299001
400 V ~ ± 10%
400 V L1-L2
6300 W
50 Hz
40°C – 650 °C / 100°F - 1200°F
0 – 7 m/min / 0 – 20 ft/min
0 - 48 l/s / 0 – 12.7 gal/s
70 dB
40 mm / 1.58"
40 – 50 cm / 1.5" – 2"
56x38x25 cm / 22"x15"x10"
30 kg / 68 lb
8 kg / 17.6 lb
4 kg / 8.8 lb (art no 299301)
91 cm / 3 ft.
Selecting the right generator
To make sure you choose the right generator,
go through these steps:
▪ Identify the items you want to run.
▪ Calculate the total surge watts required for all items.
▪ Select a generator that exceeds your total surge watts.
The multiplying factor between rated and surged
watts for TW 5000 and TH 1650 is approx. 1.2. For
instance if you run one TW 5000 (220 V) and one TH
1650 (120 V) your total surge watts will be 8040 W
((5000+1700)*1.2). Thus in this case we recommend
selecting minimum a 10,000 W generator with 50-
amp service.
Be sure to verify wattage requirements for starting
and running. Start one item at a time beginning with
the largest and ending with the smallest.
- 4 -
299047
220 / 230 V ~ ± 10%
220 V L1-L2 / 230 V N-L1
5000 W
60 Hz / 50 Hz
40°C – 650 °C / 100°F - 1200°F
0 – 7 m/min / 0 – 20 ft/min
0 - 48 l/s / 0 – 12.7 gal/s
70 dB
40 mm / 1.58"
40 – 50 cm / 1.5" - 2"
56x38x25 cm / 22"x15"x10"
30 kg / 68 lb
8 kg / 17.6 lb
4 kg / 8.8 lb (art no 299301)
91 cm / 3 ft.