Storage And Transport - Sievert TW 5000 Mode D'emploi

▪ Unscrew the three screws and
remove the heat shield on nozzle and
unplug the sensor carefully.
▪ Remove used heating element by
pulling it away from its connection.
Insert new heating element for 230 V
or 400 V respectively.
CLEANING
▪ Do not clean the TW 5000 hot-air welding machine
with a water spray or similar.
▪ Clean the welding nozzle with a brass wire brush.
▪ For optimum machine performance keep the silicone
wheels and belt clean from dirt.
▪ Annual maintenance shall be carried out by an
authorized service centre.

STORAGE AND TRANSPORT

▪ Store product indoors when not in use – out of the reach of children.
▪ Always transport and store the TW 5000 in the provided steel box, to prevent the machine from being damaged
or exposed to improper weather conditions.
MAINTENANCE
1
▪ Release the four screws on the
nozzle flange.
4
▪ Important! Replace the tube for
the heating element, to prevent air
passing in between the nozzle and
the element.
GB
2
5
!
WARNING! Touching the element
housing and/or nozzle during or after
operation could cause burns.
- 9 -
▪ Take off the nozzle by turning it
clockwise and pulling it away from
the fan housing.
▪ Replace the nozzle and turn it until
screws are locked. Tighten the screws.
▪ Plug in the sensor and replace the
heat shield on nozzle.
3
6