Bimar RD-40F Notice D'instructions page 12

the plug point and the plug of the appliance, have the plug replaced with q suitable one
by professionally qualified personnel, who will make sure that the section of the wires of
the outlet is suitable for the power drawn by the appliance. In general, the use of adapters
or extension cords is not recommended; if their use is necessary, they must conform to
existing safety standards and their current capacity (amperes) must not be less than the
maximum of the appliance.
 Before each use, check that the equipment is in good condition, that the power cord is
not damaged: if in doubt consult a qualified professional.
 The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
 Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
-
falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
-
make sure that the front is free of floating materials (dust, etc.).
 The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
 Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined
surface (the appliance could fall over).
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged,
if the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
If in doubt, have the appliance checked or assembled by a qualified professional person.
For assembly, refer to figure.
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and protection grid.
Attention: always unplug the appliance before you assemble.
12/36