Braun Silk-epil Legs & Body LS 5100 Mode D'emploi page 10

Shaving the underarm and bikini area:
Always stretch your skin when shaving.
Bikini area styling:
For trimming precise lines and contours,
lock the long hair trimmer by sliding the
TrimLock to the position «
To trim hair to a uniform length, lock the
long hair trimmer and place the bikini
zone trim attachment (6) onto the shaver
head (C2). For optimum results, move the
appliance slowly against the direction of
hair growth.
When you are finished
After shaving, you may want to smooth
on a little body cream or lotion. However,
avoid using irritating substances like
deodorants with alcohol right away.
Cleaning
Cleaning the shaver head with the
brush (D1)
• Press the release buttons (1e) to
remove the shaver head. Tap the
bottom of the shaver head gently on a
flat surface (not on the foil).
• Brush out the cutter block and the
inside of the shaver head. However, do
not clean the shaver foil with the brush
as this may damage the foil.
Cleaning the shaver head under
running water (D2)
• Press the release buttons to remove
the shaver head.
• Rinse the shaver head and the cutter
block separately under warm running
water. A natural based soap may
also be used provided it contains no
particles or abrasive substances.
Rinse off all foam.
• Leave the cutter block and the shaver
foil to dry separately.
» (C1).
Keeping your Braun Silk·épil
in top shape
• The shaving parts need to be
lubricated regularly every 3 months (E).
If you clean the shaver head under
running water, lubricate it after each
cleaning.
Apply some light machine oil or
vaseline to the shaver foil and the
metal parts of the long hair trimmer.
Then remove the shaver head and also
apply a tiny amount of vaseline as
shown in picture section (E).
• The shaver foil and the cutter block are
precision parts that wear out with time.
To maintain optimum shaving perform-
ance, replace your foil and cutter block
when you notice a reduced shaving
performance.
• Do not use the shaver head with a
damaged shaving foil.
• How to replace the shaving parts
Shaver foil: Press the release buttons
to remove the shaver head. To remove
the shaver foil, press the blue plastic
frame (F). To mount a new one, insert it
from inside the shaver head.
Cutter block: To remove the cutter
block, press and turn it 90° (G1), then
take it off. To put on a new cutter
block, press it onto the cutter block
holder and turn 90° (G2).
• Replacements parts (shaver foil, cutter
block) can be obtained from your
retailer or Braun Customer Service
Centres.
Subject to change without notice.
Disposal
This product contains batteries and
recyclable electronic waste. To
protect the environment, do not
dispose of these in the household
waste, but take them to appropri-
ate local collection points.
11