Blaupunkt BLUEBOT XVAC Mode D'emploi page 21

INSTALLATION INSTRUCTIONS
1. Connect the power line and feed the excess wire into the slot
2. Place charging station against the wall and connect the power
3. Please do not arbitrarily move the charging station and keep it out of direct sunlight
If the robot cannot be started due to a low battery, please charge the robot on the charging station and the robot will
be started automatically. The robot can only work normally when the battery level is >20%. As shown in the picture,
the charging station is correctly positioned in front of the robot and the distance between the front of the robot and
the charging station should be about 2cm. The charging plates of the robot need to connect to the charging plates of
the charging station.
4. Installation of the side brushes
Make the left-side brush (L) and the right-side brush (R) correspond to L and R on the bottom casing, press L and R and the side brushes
are installed when you hear a "cracking" sound
5. Starting up and charging
to switch on the robot. Charge the robot on the charging station when the power indicator light is normally on.
Press and hold
6. Connect the mobile APP (optional)
Please download the BlueBot App in the ANDROID or IOS store. Then refer to the WiFi connection guideline in a later section of this
manual, then connect mobile APP
7. Start cleaning
After the robot is powered on, short press key
ON/OFF
Press and hold the ON/OFF key for 3 seconds to turn the robot on or off
Clean/Pause
After the machine is started, short press the ON/OFF key on the robot or start the machine using mobile APP or the remote control.
• The machine cannot shut down when the robot is being charged
• The cleaning robot cannot be used to remove liquids
• If the battery level is less than 20, the machine cannot work. Please charge it
• The machine will return to the charging station automatically if the battery level is less than 20%
• Please clear various wires (including power line of charging station) on the ground before use so as to avoid outage and
damage of objects or wires when wires are dragged by the robot
on the robot or use the mobile APP or the remote control to start cleaning.
21
EN