Medisana MS 1000 Mode D'emploi page 15

Overview of all buttons on the remote control (advanced functions):
t LED lighting function
Each time this button is pressed, the colours of the LED lighting are ch-
anged in the order Red>Blue>Green>Three colours in automatic cycle>Switch off.
Note: When the massage chair is switched on, the three colours of the
automatic cycle are run through. The automatic programs have preset LED
colours. Press the button to change the LED colour.
u Button for manual selection of the massage method:
Switch through in the following order: Kneading, Swedish, Tapping,
Shiatsu, Calpping, Roll massage, end function.
Note: Kneading, Swedish, tapping, shiatsu and tapping massage each
have two selectable massage sequences.
z (only with kneading massage activated): Change the intensity of the
massage in 5 steps.
d (only with tapping, clapping, swedish or shiatsu massage activated):
Change the speed of the back massage in 5 steps
s For tapping, clapping, shiatsu, roll massage: Change the distance bet-
ween the massage heads in 3 steps.
i Vibration: Switch the vibration of the seat on and off.
Also works with the automatic programs.
o Air pressure massage of the whole body (automatic mode): on/off
p Manual selection of air pressure massage areas:
Leg support -> Arm support -> Shoulders -> Off
a Adjust the intensity of the air pressure massage in 5 steps
(works in automatic and manual mode)
3.4 Bluetooth Function
The speaker of the massage chair only works when the device is switched on.
Connect your Smartphone, Tablet or PC to the massage chair via Bluetooth.
3.5 Switching off the device
Press the Power button 9 on the remote control.
All functions are terminated - but the massage heads are still moving to
their parking position. Wait a few seconds.
Then set the on/off switch (position 8 ) to position „O" and disconnect the
device from the power socket.
3.6 Troubleshooting
problem possible cause
The device does not The device is not plug-
work ged in properly
The device stopped The device has just
working finished its auto timer
session and has auto-
matically switched to
standby mode.
The device stopped You may have used
working the device continuous-
ly for 45 minutes
where the over-heat
protection has been
activated.
The device stopped An excessive load has
working been applied on the
device.
The device is abnor- The device is likely to
mally warm be overused.
Noise can be heard Noise is made by the
from the device mechanical parts of
the device.
If the problem encountered is not listed, please try the following suggestions:
1. Turn off the product and unplug it.
2. Wait for 60 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem persists, contact the authorized service center.
The service centre address is shown on the attached leaflet.
GB
3 Operating
suggestion
Ensure the voltage
on the device corre-
sponds to the local
mains voltage and
then plug in again.
Make sure the outlet is
properly working.
If you want another
session, press the
power button again.
Unplug the device and
let it cool down for 60
minutes before you
use it again.
Reduce the excessive
load and start again.
Unplug the device and
let it cool down before
using it again.
This is normal and
does not mean that
the device is faulty.
15