Melnor Aqua Timer 3060 Mode D'emploi page 5

BATTERY INSTALLATION
1. Open rear battery door by removing the three screws using a Phillips head
screw driver.
2. Install two new AA alkaline batteries (not included) in the position indicated
in the battery compartment.
3. Replace the battery door and secure with screws. The timer will automatical-
ly enter timeset mode. The motor may activate to reset the unit.
Additional Battery Information
• Good quality, fresh alkaline batteries should last one watering season.
• Replace the batteries at the beginning of each watering season.
• Remove the batteries when the timer is not in use for an extended period of
time.
• When the batteries become weak, the unit will display LOW BATTERY. If the
valve is open at that time, the timer will close the valve. It will not activate or
open manually until the batteries are replaced.
2