Télécharger Imprimer la page

MaxxGarden 20999 Mode D'emploi page 34

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
The hose should be secured to the regulator and the appliance with hose clips/nut. This
barbecue is set to operate a 28-30 mbar regulator with butane gas or a 37mbar regulator
with propane gas.
Use a suitable regulator certified to EN16129. Please consult your LPG dealer for information
regarding a suitable regulator for the gas cylinder.
• Max 9" side cooker is allowed for this appliance.
INSTALLATION
Selecting a Location
This barbecue is for outdoor use only and should be placed in a well-ventilated area, and on
a safe and even surface. Never place your barbecue below ground level. Take care to ensure
that the barbecue must be used on an incombustible floor. The sides of the barbecue should
NEVER be closer than 1 metre from any combustible surface, including trees and fences and
make sure that there are no heat sources near the barbecue (cigarettes, open flames, spark
etc.). Keep this barbecue away from any flammable materials!
Precautions
Do not obstruct any ventilation openings in the barbecue body. Position the gas bottle on
level ground next to the barbecue and safely away from any source of heat. Should you need
to install or change the gas bottle, confirm that the barbecue is switched off, and that there
are no sources of ignition (cigarettes, open flame, sparks, etc.) near before proceeding.
Fixing a Regulator to the Gas Bottle
Confirm all barbecue control knobs are in the off position. Connect the regulator to the gas
bottle according to your regulator and bottle dealer's instructions.
Leak Testing
(Always perform a leak test in a well-ventilated area) Confirm all control knobs are in the off
position. Turn the gas on/ open the gas control valve on the gas bottle or regulator. Check for
leaks by brushing a solution of½ water and ½ liquid detergent/ soap over all the gas system
joints, including gas bottle valve connections, hose connections, and regulator connections.
NEVER USE AN OPEN FLAME to test for leaks at any time. lf bubbles form over any of the joints
there is a leak. Turn off the gas supply at the gas bottle. Retighten all joints. Repeat test. lf
bubbles form again do not use the barbecue and contact your local distributor for assistan-
ce. Always wipe the mixed solution (½ water and½ liquid detergent/ soap) from all joints and
connections after leak testing.
34

Publicité

loading