Maintenance - Craftsman C935-355170 Guide D'utilisation

Before each mowing session unplug the mower and ensure that the blade
has stopped. Check all nuts, bolts and screws to ensure proper tightness,
Be sure to check the blade fastening system.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (including brush inspection and replacement)
should be performed by SEARS Service Centres or other qualified service
organizations, always using Sears replacement parts. When servicing use
ONLY IDENTICAL REPLACEMENT PARTS.
REMOVING AND ATTACHING BLADES (FIGURE 10,11,12)
1. RELEASE SWITCH LEVER TO TURN MOWER OFF, WAIT FOR THE BLADE TO
STOP, AND UNPLUG MOWER!
2. Use a piece of 2x4 wood (about 2 feet long) to keep blade from turning while removing
blade nut.
3. Wear gloves. Position wood and remove nut as shown in Figure 10.
4. Remove lower blade spacer, lower insulator washer and blade. (Figure 11)
5. When replacing sharpened or new blade on shoulder of fan, make sure the "GRASS
SIDE" identification on the blade is facing the ground. Place lower insulator washer
over shoulder of the fan. Now place lower blade spacer and the blade nut on the
shaft.
NOTE: Align flats of shaft with flats in lower insulator washer and lower the blade space.
Position wood to keep shaft from turning (Figure 12) and then securely tighten
blade nut.
10
11
LUBRICATION
No lubrication is necessary. Do not oil the wheels. They have plastic bearing surfaces which
require no lubrication.

MAINTENANCE

SERVICE and ADJUSTMENTS
12
Inspect and thoroughly clean your mower at the beginning of each mowing
season for longer life and better performance.
From time to time turn the mower off and wait for the blade to stop. Then
unplug the power cord and turn the mower on its side. Using an object such
as a stick or rag, wipe out any accumulation of grass in the blade area. Also
clean out any grass or debris which may be packed around the
discharge/mulch door area. Be careful of the sharp edges of the blade.
SHARPENING AND BALANCING THE BLADE: (FIGURE 13,14)
1. BE SURE THE SWITCH LEVER IS RELEASED AND THE BLADE HAS STOPPED
AND THE CORD UNPLUGGED BEFORE REMOVING THE BLADE.
2. Remove blade from mower. See instructions for removing and attaching blade.
3. Secure blade in a vise as shown in Figure 13.
4. Wear safety glasses and be careful not to cut yourself.
5. Carefully file the cutting edges of the blade with a fine tooth file or sharpening stone.
6. Check balance of blade by placing centre hole in blade over a nail or screwdriver
shank, clamped horizontally in a vise. If either end of the blade rotates down, file off
additional material from that end. Blade is properly balanced when neither end
drops. (Figure 14))
7. Replace blade on mower and tighten securely.
13
7
14