Assembly - Craftsman C935-355170 Guide D'utilisation

UNPACKING AND ASSEMBLY
BEFORE ASSEMBLING YOUR MOWER, CHECK THAT YOU HAVE
RECEIVED THE FOLLOWING IN THE SHIPPING CARTON. SEE FIGURE 1.
A. Mower
B. Upper Handle
C. Lower Handle
D. Discharge Chute
E. Plastic Bag with handle bolt, wing nuts, star washers, cable tie and shroud
hole covers.
A
D
B
ASSEMBLING THE HANDLE
1. Your mower carton contains the mower, 2 handles, discharge chute and 1
plastic parts bag.
2. Fasten the upper and lower handle halves together using the eye bolt
(already installed on the power cord) and the bolt and wing nuts from the
plastic bag. Make sure the power cord and switch are on the same
side of the mower as the discharge area. The eye bolt is installed so
that the cord is routed to the outside. Place star washers on the bolts
between handle and the wing nuts. Tighten the wing nuts securely.
2
C
E
FIGURE 1
FIGURE 2

ASSEMBLY

ATTACHING THE HANDLE
1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE
STOP.
2. Brace the front end of the mower so that it cannot roll forward.
3. Slide the shroud hole cover retaining loop over the end of the handle.
Ensure that the arrows on the hole covers are pointing towards each other
when installed. (Figure 3A)
4. Align the ends of the lower handle with the holes in the lawnmower shroud.
(Figure 3B)
5. Push the handles into the lawnmower until they are fully engaged taking
care not to pinch or damage the power cord.
6. Pull back on the handles to ensure a secure fit.
7. Install shroud hole covers by inserting the bottom edge of the shroud hole
cover onto the bottom edge of the shroud hole, then rotate hole cover
forward and push down until it is firmly snapped into position in the shroud.
(Figure 3C)
8. Install cable tie on lower handle to secure cord.
CAUTION:
!
out
MULCHING
The mower is designed to mulch or discharge the grass depending on whether
the mulch door is closed (mulching) or the mulch door is up and the discharge
chute is in place (discharging). No further assembly steps are required if you
are mulching. PROCEED TO OPERATION SECTION PAGE 6.
DISCHARGE CHUTE INSTALLATION
(If you wish to discharge the clippings rather than mulch,
perform these steps)
1. UNPLUG TOOL, AND WAIT FOR BLADE TO COME TO A COMPLETE
STOP.
2. Open mulch door by pulling on the mulch door finger grip. (Figure 4A)
3. Align the discharge chute arrows with the positioning arrows on the
lawnmower deck and insert the discharge chute as shown.
4. Position the chute until the chute hooks are trapped under the deck hooks
and release the chute and door. (Figure 4B)
2
A
FIGURE 3
NEVER use a sharp object to move jacketed wires
out of the way.
A
FIGURE 4
C
B
B