Publicité
Les langues disponibles
Les langues disponibles
Transport of li-ion battery packs:
The shipping of li-ion battery pack is subject to laws related to the
carriage of hazardous goods (UN 3480 and UN 3481). Inform yourself
of the currently valid specifications when shipping li-ion battery packs.
If necessary, consult your freight forwarder.
Only send the battery pack if the housing is intact and no fluid is
leaking. Remove the battery pack from the machine for sending.
Prevent the contacts from short-circuiting (e.g. by protecting them with
adhesive tape).
For further safety instructions please refer to the enclosures!
Battery pack
Charge the battery pack (1) before use. If performance diminishes,
recharge the battery pack.
The ideal storage temperature is between 10°C and 30°C.
Li-Ion battery packs "Li-Power" have a capacity and signal indicator (2):
•
Press the button (3), the LEDs indicate the charge level.
•
If one LED is flashing, the battery pack is almost flat and must be
recharged.
Removing the battery pack
Press the battery pack release button (4) and pull the battery pack (1)
forwards.
Inserting the battery pack
Slide the battery pack (1) in until it engages.
Switching on and off
Short-Time Operation
Switching-on:
press on/off switch (5)
Switching-off:
release on/off switch (5)
Permanent Operation
Switching-on:
press the on/off switch (5) and, keeping it pressed, engage
the lock-on button (6)
Switching-off:
press the on/off switch (5) and release it again
The machine is equipped with an electronic switch.
With this switch the speed can be regulated according how much pressure
you apply. The use is only recommended for start drilling easily.
A permanent operation with reduced speed will lead to an overload, as less
cooling air will then be available for the motor which consequently overheats
much faster.
Commissioning
14
Publicité
