Sharp AR-FR7 U Mode D'emploi page 6

■ SECURITY SETTINGS
1-(1) CLEAR ALL MEMORY
Use this setting when you wish to manually clear data stored in the unit's memory
and on the hard disk.
NOTE
We recommend that you execute this program before turning off the power.
Touch the [CLEAR ALL MEMORY] key. The following screen appears to confirm
your selection.
[Clear screen 1]
CLEAR ALL MEMORY?
(RESERVED JOB DATA WILL BE CLEARED.)
[Clear screen 2]
CLEARING ALL MEMORY. AUTO REBOOT IS
IMPLEMENTED AFTER CLEARING.
PROGRESS STATUS
0
%
NOTE
If you wish to cancel after data clearing has begun
Touch the [CANCEL] key. When the [CANCEL] key is touched, the key operator code
entry screen appears. Enter your key operator code with the numeric keys. Note that
data that has already been cleared at the time you enter your 5-digit key operator code
will not be restored. Data already cleared will be lost. When data clearing is canceled,
the machine will power off temporarily and then automatically power back on.
1-(2) NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED
This program is used to enhance the security function. The repeat count for "CLEAR
ALL MEMORY" can be set to any number from 1 to 7. The factory setting is 1.
Touch the [NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED]
key, and set the desired number of times with the
When finished, touch the [OK] key.
(See "About the repeat count setting" on page 5 of this manual.)
NO
CANCEL
50 100
% %
To return
●
SETTINGS" screen, touch the [NO] key.
When the [YES] key is touched, the
●
following screen appears.
YES
The example
appearance of the screen when a hard
disk is installed. The screen differs
according to whether a hard disk is
installed.
Each time the top bar reaches all the way
●
to the right, the bottom bar, which
indicates
advances 1%. (When the bottom bar
reaches 100%, date clearing is finished.)
4
to the "SECURITY
at left shows
date clearing
or key.
the
progress,