EMKO ESM Serie Mode D'emploi page 15

out3 ConF: MODULE-3 parameters
Output-3 Logic output function
Alarm output
Sensor break alarm output
Output is active when the process value is out of the band
which is defined with minimum value of operating scale
Alarm-3 Type
Process high alarm
Process low alarm
Alarm-3 hysteresis value (0% of scale, 50% of scale)Unit
This parameter is active, if the Logic-3 output function is
Alarm output.
Alarm-3 On delay time (0, 9999)Second
This parameter is active, if the Logic-3 output function is
Alarm output.
Alarm-3 Off Delay Time (0, 9998)
When the value is greater than 9998,
screen. It means alarm latching output is selected. This
parameter is active if logic-3 output function of Alarm-3
Output is alarm output.
Alarm Types
Process High Alarm
Alarm
Output
Alarm
ON
OFF
HYS
and maximum value of operating scale
Alarm
Output
Set
Process Value
Second
is seen on the
Process Low Alarm
Alarm
Set
ON
OFF
HYS
Process Value
15