EMKO ESM Serie Mode D'emploi page 13

out1 ConF: MODULE-1 parameters
If there is EMO-X00 (Relay Output) , EMO-X10 (SSR driver)
i
and EMO-X20 (Digital Output) module in MODULE-1
socket, then the following parameters is active.
MODULE-1 output module Logic output function
Alarm output
Sensor break alarm output
Output is active when the process value is out of the band
which is defined with minimum value of operating scale
and maximum value of operating scale
Alarm-1 Type
MODULE-1 alarm type. This parameter is active, if the Logic-
1 output function is Alarm output.
Process high alarm
Process low alarm
Alarm-1 hysteresis value (0% of scale, 50% of scale)Unit
This parameter is active, if the Logic-1 output function is
Alarm output.
Alarm-1 On delay time (0, 9999)Second
This parameter is active, if the Logic-1 output function is
Alarm output.
Alarm-1 Off Delay Time (0, 9998)
When the value is greater than 9998,
screen. It means alarm latching output is selected.
parameter is active
Output is alarm output.
out1 ConF: MODULE-1 parameters
If there is EMO-X30 (
i
module in MODULE-1 socket, then the following
parameter is active.
MODULE-1 analogue output module configuration
0...20mAZ output
Scale
Re-transmission
UPL
LOL
0
Second
if logic-1 output function of Alarm-1
0/4...20 mA Z Current output
4...20mAZ output
Scale
Re-transmission
UPL
LOL
mA
20 0 4
is seen on the
This
)
mA
20
13