Deleting A Cycle - Drucker Diagnostics HORIZON 24 FLEX Manuel De L'opérateur

S M
ETTING OR ODIFYING A
Up to 10 cycles can be named, programmed for time, speed, and braking, and saved in memory. The top screen
alternates between cycle name and speed when not in programming mode.
Cycle Selection
Enter Settings
Setting by g-Force
(Recommended)
Setting Speed
Change Brake
Naming the Cycle
Settings Mode
D C
ELETING A YCLE
To delete a selected cycle, press the GEAR button and simply set either TIME or SPEED to zero and save by pressing
the CYCLE button.
S C
AVED YCLE
Press the CYCLE button until the number for the cycle to be
programmed or changed is displayed.
Press the GEAR button. The word "Speed" appears on the top
Mode screen.
While the top screen displays SPEED, press and hold the RCF (xg)
button while changing the displayed setting, using the up and
down buttons next to the bottom screen. The RPM will
automatically adjust.
If the g-force is set correctly, the speed does not need to be set
separately. To change the speed (RPM) shown on the bottom
display, use the up and down buttons next to it. The G-force will
(Alternate)
adjust automatically and can be verified by pressing the RCF
button.
Navigate with the down key next to the top screen until it shows
Setting Time
"Time". Press the up and down buttons next to the bottom TIME
display to adjust time.
Navigate with the down key next to the top screen until it shows
"Brake". To change the value shown on the BRAKE display, use the
Values
up and down buttons next to the BRAKE screen.
Press the up and down keys next to the upper screen until
Turn Beeper
"Beeper" shows on the upper screen. Switch ON or OFF with the
On or Off
keys next to the lower screen. This setting will apply to all cycles.
Navigate to the cycle name with the UP and DOWN arrows. The
current name of the cycle is displayed and can now be changed.
Press the START button. The * indicates the character selected.
Change it to the desired character with the up and down buttons,
then move to the next character with the right arrow >. Repeat.
Press the GEAR button to get back to the main programming
menu. A beep indicates that the name has been saved.
Press and hold the CYCLE button you hear a double beep. The new
parameters will be saved to the cycle number displayed on the
Save and Exit
screen to the right.
Note: if the GEAR button is pressed before the CYCLE button, all
changes will be lost.
| 8