Care And Cleaning - Zanussi ZOU362 Notice D'utilisation

Care and cleaning

Warning! Before you clean the appliance, switch it
off. Make sure that the appliance is cold.
Warning! Do not clean the appliance with steam
cleaners or high-pressure cleaners.
Caution! Do not use corrosive or scouring cleaning
agents, sharp objects, stain removers or abrasive
sponges.
Warning! Do not clean the glass door with abrasive
cleaning agents or metal scraper. Heat resistant
surface of the inner glass can damage.
Caution! If you use an oven spray, follow the
instructions from the manufacturer.
• Clean the front of the appliance with a soft cloth with
warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can
remove dirt more easily and it does not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with warm
water and cleaning agent) after each use and let them
dry.
• If you have nonstick accessories, do not clean them
using an aggressive agents, sharp edged objects or
dishwasher. It can destroy nonstick coating!
Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
16
2
1
2
Pull the rear shelf sup-
port rail away from the side
wall and remove it.
The rounded ends of the shelf support rails must
point to the front!
Cleaning the oven door
Before you clean the oven door, remove it from the oven.
Warning! Make sure that the glass panels are cool,
before you clean the glass door. There is risk that
the glass breaks.
Warning! When the door glass panels are damaged
or have scratches, the glass becomes weak and can
break. To prevent this you must replace them. For more
instructions, speak with your local Service Centre.
1
Open the door fully
and hold the two door
hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat. Place the door on
a stable surface protected
by a soft cloth.
Clean the glass panel with water and soap. Dry it carefully.
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in reverse.
2
Lift and turn the levers
on the two hinges.