Door Reversal - Amana BC21VC Mode D'emploi

A
B
A Roller adjustment screw
B Bottom hinge cover

Door Reversal

Some installations may require door reversal to achieve
full door swing. To reverse door swing direction perform
the following steps:
Tools Required
Putty knife (blade covered by masking tape)
5
/ " hex nut driver
16
3
/ " hex nut driver
8
1 / " hex nut driver
4
Phillips screwdriver
Blade screwdriver
1. Remove refrigerator handle.
• Remove handle screw from top handle trim. Pry up
edge of handle trim using a putty knife with the
blade covered with masking tape. Remove handle
from door by removing 1 remaining mounting screw
at each end of handle.
• Remove 1 plug from top hinge side of door and 2
from front hinge side of door. Replace 3 plugs in
empty mounting holes.
A
D
C
A
A Handle trim
B Name plate
C Handle
IMPORTANT: For plug removal requiring use of flat blade
screwdriver or putty knife, blade of tool must be
covered with masking tape to avoid damage to
refrigerator finish. For plugs using a screwdriver- or nut
driver- style head, use appropriate tool to avoid damage
to plugs.
2. Remove freezer door handle.
• Open freezer door 90°. Locate two notches on
back of freezer handle. Insert flat screwdriver
C
C Stabilizing leg
(some models)
B
E
D Screw
E Plugs
driver blade or putty knife blade wrapped in
masking tape. Pry up back edge of handle cap
and remove from handle.
• Remove handle from door by removing two
mounting screws.
• Remove 2 plugs from opposite side of freezer door
and replace in empty mounting holes.
A
A Freezer handle
B Handle cap
3. Remove top hinge cover. Top hinge cover snaps off.
Remove top hinge and hinge shim using hex nut
driver. Remove and retain all shims.
4. Remove refrigerator door by lifting door off of center
hinge pin. Inspect door to verify all shims are with
hinge pin.
5. Remove center hinge pin using hex nut driver. Due to
tight fit of pin, firm pressure may need to be applied.
Remove and retain all shims.
6. Remove freezer door by lifting door off bottom hinge.
7. Remove center hinge bracket and shim using Phillips
screwdriver.
8. Remove toe grille and bottom hinge cover. Both snap
off.
9. Remove bottom hinge and hinge shims using hex nut
driver. Remove and retain shims.
A
B
I
E
F
G
I
J
K
M
A 5/16" hex nut screws
B Top hinge
C Hinge shim(s)
D Round shim(s)
E 5/16" hex nut
F Center hinge pin
G Center hinge
H Center hinge shim(s)
4
B
C
D
C Screws
D Plugs
C
D
H
D
L
I Phillips screws
J Bottom hinge pin
K Bottom hinge
L Bottom hinge
shim(s)
M 3/8" screws