Chamberlain RJO20C Mode D'emploi page 30

Programming
Reprogramming Remote Light or Additional Light
Your garage door opener remote light has already been programmed at the
factory to operate with your opener. Any additional or replacement remote
lights will need to be programmed.
1. Press the LEARN button on the light until the LED comes ON.
2. Activate the garage door opener using the hand-held remote, door control,
or keypad.
3. The code has been programmed when the remote light comes on.
HomeLink
®
In the rare case the HomeLink system does not program with the
Security+ 2.0 Garage door opener, install a repeater kit. Refer to
HomeLink instructions below.
HomeLink is the in-vehicle system. The image used is for reference only
and your product may look different.
WHEN TO INSTALL A HOMELINK REPEATER KIT
All 2006 and older vehicles – A repeater kit is required and must be
purchased by the homeowner.
All 2007 and newer vehicles – Program the HomeLink according to the
vehicle instructions. If after ONE attempt to program the HomeLink to the
garage door opener and you are unsuccessful, install a repeater.
HOW TO ORDER
Order the HomeLink repeater kit from an installer or call 1-800-355-3515.
To program the HomeLink repeater kit, refer to the instructions provided in the
kit or visit: http://www.homelink.com/program.
INSTALLATION QUICK FACTS
• Only one repeater kit is required per home.
• Use different HomeLink buttons in vehicle if programming multiple cars,
button 1 first car, button 2 second car... etc.
• HomeLink remote is NOT a garage door opener.
• If you are using the HomeLink repeater with a garage door opener that has
a battery backup system, ensure your original garage door opener remote
control is programmed to the garage door opener and place it in your glove
box for use in the event of a power outage.
• The remote included in this repeater kit MUST be kept for future
programming - new vehicle, new garage door opener, etc.
(continued)
30
HomeLink
®
I II III
Repeater Kit