Starting The Dishwasher; Time Remaining; Status Light; Stopping Or Changing A Program - Pelgrim GVW321XL Notice D'utilisation

1. Press the button once to activate Delayed start. Press the button several times – or hold it in – to
set the desired number of hours.
2. Close the door and the dishwasher counts down 1 hour at a time and starts after the selected
delay.
If you want to cancel the Delayed start option, open the door and press and hold the main power
switch until the display turns off.

Starting the dishwasher

Close the door to start the dishwasher. If the main power switch is on the dishwasher will start
automatically when the door is closed.

- Time remaining

Once you have chosen a program and options, the time the program took when last used is displayed.

Status light

The status light on the bottom part of the dishwasher indicates that a program has started.
Flashing light
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting.

Stopping or changing a program

If you want to change program after starting the dishwasher, open the door then press and hold the
main power switch until the display turns off. Add more detergent if the lid of the detergent dispenser
has opened. Then press the main power switch, select a new program and close the door.

If you want to load more dishes

Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a while,
the dishwasher continues the program.

If the dishwasher is turned off due to a power failure

If the dishwashing program was not finished, the interrupted program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than
2 minutes.
16
Status light