Publicité
Les langues disponibles
Les langues disponibles
Front Panel：
1. MICROPHONES:
DJ/Mc have their own dedicated level control. Microphones have individual 2 band EQ section
2. Wireless microphone
Let you use the wireless microphone connect to the mixer. The blue LED will trun on if keep a good connected.
3. ECHO DELAY CONTROL
Let you adjust the delay tine for echo.
4. ECHO REPEAT CONTROL
Let you control the time period during which the echo is repeated.
5. TONE CONTROLS
Each channel has dedicated Bass, Mid and High controls. NOTE: Care should be taken not to distort the output signal
using these controls.
6. MIC LEVEL CONTROL
Let you control the MIC level as they enter the mix.
7. TALKOVER
This is a two position switch OFF/ON
8. CHANNEL LEVEL FADERS
These are used to adjust the output level for each channel.
9. CROSSFADER
The crossfader allows the mixing of one source into another. The crossfader in your unit is removable and can be easily
replaced if needed.
10. CHANNEL SELECTORS
These are used to switch between Line input and PHONO、MIC input on each channel.
11. AUX INPUT
Music can input the mixer with 3. 5mm audio line.
12. Bluetooth
Display Bluetooth working status. When you turn on the power, the Bluetooth is turn on, the lights started flashing in the
online state. At this time in addition to the Bluetooth device can find and connect it. A minute later, if connectionless
lights out and enter the standby mode. If the Bluetooth connection by a player, the light flashes slowly, about 2-3
seconds flicker once. At this point you can use the Bluetooth player playing music can hear the music of the
corresponding channel.
13. DISPLAY
The unit has two LED displays Left output, Right output the left and right output display shows the
Outputs level of the mixer
Publicité
