TrekStor i.Beat cebrax RS Mode D'emploi page 11

Les langues disponibles

Mode: Settings

Switch to the "s

" mode.

ettings

This mode allows you to set the equalizer, the different playback functions, the duration of the

display, the contrast, the energy-saving mode and the sleep timer.

Push the joystick to the left  or the right  to select the desired setting, and confirm by

pressing the  button.

Mode: System

Switch to the "s

" mode.

ystem

In this mode, you can display the current firmware version, the entire memory and free memory

i.Beat cebrax RS

of the

Push the joystick to the left  or the right  to select the desired information or setting, and

confirm by pressing the  button.

Note:

• This MP3 player is optimized for the provided earphones (32 Ohm impedance). Using other earphones with a lower impedance

can damage the MP3 player or earphone, especially MP3 players with 2 earphone jacks.

• Exposing the unit to an electrostatic discharge, among other things, may interrupt the data transfer between the unit and the

computer. If this occurs, the unit should be unplugged from the USB port and then plugged in again.

• Note: This device can produce high volumes. To prevent hearing loss, do not listen to high volumes for long periods. If you notice a

ringing noise in your ears, lower the volume immediately or stop using the MP3 player. Please keep in mind that using earphones or

headphones at loud volumes may result in permanent hearing loss. While you become accustomed to higher volumes over time, so

that they may seem normal to you, your sense of hearing can still be impaired. The higher you adjust the volume, the faster your

sense of hearing can be damaged.

• Note: Using earphones while driving a motor vehicle is not recommended and is prohibited in some countries. Always drive carefully

and with full concentration. Stop using your MP3 player if you become distracted or interrupted by it when driving a motor vehicle or

during other activities that require your full attention.

• Do not use USB cables longer than 3 meters.

The manufacturer retains the right to continuously improve the product. These changes may be made without being directly

described in these quick guides. For this reason, the information provided in these quick guides may not reflect the current

state of the art.

The manufacturer only guarantees suitability for the product's intended purpose. In addition, the manufacturer is not

responsible for damages or loss of data and subsequent consequences.

brand names of the respective owner.

. You can also set or load the language and the default settings.

– 11 –