General Safety Information; Specifications - Campbell Hausfeld VH300300 Instructions D'utilisation

Operating Instructions and Parts List

General Safety Information

(Continued)
GENERAL SAFETY
Since the air compressor and other
components (material pump, spray
guns, filters, lubricators, hoses, etc.)
used, make up a high pressure pumping
system, the following safety precautions
must be observed at all times:
1. Read all manuals included
with this product
carefully. Be thoroughly
familiar with the controls
and the proper use of the
equipment.
2. Follow all local electrical and safety
codes as well as in the United States,
the National Electrical Codes (NEC)
and Occupational Safety and Health
Act (OSHA).
3. Only persons well acquainted with
these rules of safe operation should
be allowed to use the compressor.
4. Keep visitors away and NEVER allow
children in the work area.
5. Wear safety glasses and
use hearing protection
when operating the unit.
6. Do not stand on or use the unit as a
handhold.
7. Before each use, inspect compressed
air system and electrical components
for signs of damage, deterioration,
weakness or leakage. Repair or
replace defective items before using.
8. Check all fasteners at frequent
intervals for proper tightness.

Specifications

Motor
Model Running HP*
VH300300 3.0
* Note: Motor should be a 3450 RPM compressor duty motor.
www.chpower.com
equipment and controls can
cause electrical arcs that
will ignite a fl ammable gas
or vapor. Never operate or repair in or
near a fl ammable gas or vapor. Never
store fl ammable liquids or gases in the
vicinity of the compressor.
compressor without a
beltguard. This unit can
start automatically without
MANUAL
warning. Personal injury or property
damage could occur from contact with
moving parts.
9. Do not wear loose clothing or
jewelry that will get caught in the
moving parts of the unit.
Compressor parts may be hot
even if the unit is stopped.
10. Keep fingers away from a running
compressor; fast moving and hot
parts will cause injury and/or burns.
11. If the equipment should start to
vibrate abnormally, STOP the engine/
motor and check immediately for
the cause. Vibration is generally a
warning of trouble.
12. To reduce fire hazard, keep engine/
motor exterior free of oil, solvent, or
excessive grease.
ASME safety valve. Keep safety
valve free from paint and other
accumulations.
Recommended Campbell
Hausfeld Motor Part No.
MC015403IP
Motors,
electrical
Never
operate
Never remove or
attempt to adjust
Pump
Pulley RPM
4.75 O.D., AK49 1540
2
Never
attempt
to repair or modify a tank!
Welding, drilling or any other
modifi cation will weaken the
tank resulting in damage from rupture
or explosion. Always replace worn,
cracked or damaged tanks.
13. Tanks rust from moisture build-up,
which weakens the tank. Make sure
to drain tank regularly and inspect
periodically for unsafe conditions
such as rust formation and corrosion.
14. Fast moving air will stir up dust
and debris which may be harmful.
Release air slowly when draining
moisture or depressurizing the
compressor system.
15. Keep hoses away from sharp objects,
chemical spils, oil solvents and
wet floors which can damage the
hose. Do not operate compressor
with damaged hose(s) or after the
compressor or attachments have
been dropped or damaged. Notify
the nearest authorized service
facility for examination, repair or
other adjustments.
Never use plastic
(PVC) pipe for
compressed air. Serious injury or death
could result.
Free Air CFM @
Max.
Pressure 40 psig
135 psi 11.5
90 psig
10.2