Taurus Alpatec PONENT 16C ELEGANCE 5B Mode D'emploi page 8

- Check the state of the power cord. Damaged
or tangled cables increase the risk of electric
shock.
- Do not use or store the appliance outdoors.
- Do not leave the appliance out in the rain or
exposed to moisture. If water gets into the
appliance, this will increase the risk of electric
shock.
- Do not touch the plug with wet hands.
- Do not touch any of the appliance's moving
parts while it is operating.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- This appliance is for household use only, not
professional, industrial use.
- Store this appliance out of reach of children and/
or persons with physical, sensory or reduced
mental or lack of experience and knowledge.
- Make sure that dust, dirt or other foreign objects
do not block the fan grill on the appliance.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- CAUTION: There is a risk of fire if the
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
A Propeller
B Grill
C Oscillation Slector
D Control Panel
E Fan Stick
F Fan Base
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base fitted.
ASSEMBLING THE BASE:
- Fit the base with the column, and secure it with
the screws provided.
- Stand the appliance up again so as to check
that the base works properly.
ASSEMBLING THE GRILL AND THE PROPE-
LLER: (FIG.1)
- Fit the rear grill (1) on the motor housing (2),
matching their fitting points.
- Fit the propeller (3) On the motor shaft (1).
- Tight the nut (4) that attaches the propeller,
Make sure of a correct setting.
- Fit the front grill (5) front the rear grill (2), mat-
ching the security screw position. Fix the front
grill turning around its fixing belt and tight the
security screw by using a screwdriver.
- Check the correct rotation of the propeller.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has been
removed.
USE:
- Connect the appliance to the mains.
- Turn the appliance on, by using one of the spe-
ed selection buttons.
- Select the desired speed.