Cleaning Your Floors - Bissell CROSSWAVE 2593 Serie Mode D'emploi

Masquer les pouces Voir aussi pour CROSSWAVE 2593 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning Your Floors

Go to support.BISSELL.com for how-to videos and tips for cleaning stuck-on messes,
excessively dirty or muddy floors, and more!
Mode
Power
1.
To clean hard floors, turn
machine ON by pressing the
Power Button. Press the Mode
Button to switch between
the Hard Floor and Area Rug
Modes.
Area Rug Mode dispenses
twice as much solution as
Hard Floor Mode. Before
cleaning area rugs, check the
manufacturer's tag and test an
inconspicuous spot on the rug
for colorfastness. Don't use on
silk or delicate rugs.
4.
To clean, hold the Solution
Spray Trigger to apply solution
on forward and backward
passes.
ATTENTION
brush may result in premature belt failure.
8 BISSELL.com
2.
Recline the machine to start
the Brush Roll spinning. Stand
the machine upright to stop
the Brush Roll spinning.
5.
To dry floors faster, release
the trigger and make a second
pass without dispensing
solution.
Do not overwet carpet. Be careful not to run over loose objects or edges of area rugs. Stalling the
3.
Before each use, hold the
Solution Spray Trigger for 10
seconds to prime the system
with cleaning solution.
LED lights illuminate when
holding the trigger. Bubbles
will appear in the Brush Roll
window when the solution is
flowing.
6.
Turn OFF the machine by
pressing the Power Button ( ).

Publicité

Table des Matières
loading

Table des Matières