Using Your Vacuum; Above Floor Cleaning - Bissell POWERGLIDE PLUS LIFT-OFF PET 2920C Mode D'emploi

Using Your Vacuum

For additional ways to use your vacuum's features, check out support.BISSELL.ca.
1.
Turn power ON. Turn the
Brush Roll ON for carpet
cleaning and the light switch
will illuminate. Turn the Brush
Roll OFF when vacuuming hard
or delicate surfaces.

Above Floor Cleaning

Visit support.BISSELL.ca to see all the ways you can use your vacuum's tools.
1.
Push the Lift-Off Release
Button and lift up to remove
the pod from the Foot.
4.
Use the Carry Handle to
bring the Lift-Off Pod to hard-
to-clean places in your home.
WARNING
4 BISSELL.ca
2.
Step gently on base and pull
the handle back to recline.
Note: The Brush Roll
automatically shuts OFF when
vacuum is locked in upright
position. Recline to reactivate.
2.
For the most reach, use
the Quick Release Extension
Wand. Push the Release
Button to remove.
To clean without the the
wand, twist circular hose cuff
counter-clockwise and remove.
5.
Replace the wand back by
sliding into place until you hear
a "click". Reattach Hose to
Handle if needed.
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.
3.
Use the Carpet Type Control
for optimized cleaning on high
pile and low pile carpet. The
control can be moved to the
middle position for medium
pile carpeting.
3.
Attach desired tool.
Note: For optimal use, attach
the Pet TurboEraser® Tool
directly to the Hose instead of
the Handle.
6.
Place the pod back onto the
Foot.