Cleaning Your Hard Floors - Bissell CROSSWAVE 1713 Série Mode D'emploi

Cleaning Your Hard Floors

1
Plug machine into a
properly grounded
outlet.
4
Before each use, hold
the solution spray
trigger for 10 seconds to
prime the system with
cleaning solution. LED
lights illuminate when
holding the trigger.
NOTE: When solution
is flowing, you will see
bubbles forming at the
edges of the brush roll
window.
ATTENTION
Do not over wet carpet. Be careful not to run over loose objects or edges of area rugs.
Stalling the brush may result in premature belt failure.
2
Select
cleaning
mode:
To start cleaning your hard
floors, turn the machine ON
in the HARD FLOOR setting.
Once the setting is selected,
the dry vacuum will turn on.
To turn OFF, press the HARD
FLOOR setting a second time.
5
To clean, hold the solution
spray trigger to apply
solution on both forward and
backward passes.
NOTE: Hold machine over
stuck on messes while holding
the trigger for best results.
3
Recline the body of
the machine backward
to start the brush roll
spinning. To stop the
brush roll spinning, you
will need to stand the
machine upright.
6
For overly challenging
and stuck-on messes
on your hard floors,
activate the RUG
mode and hold your
CrossWave™ over the
mess.
Using short passes while
holding the trigger
allows the multi-surface
brush to go to work.
www.BISSELL.com
7