Using The 3-In-1 Docking Station; Storing Your Machine - Bissell CROSSWAVE 2593 Serie Mode D'emploi

Using the 3-in-1 Docking Station

Open the BISSELL Connect App to watch a full walkthrough video on the dock.
Charging starts once the machine is placed onto the plugged-in dock. Charging stops once the Clean
Out Cycle runs, then resumes once the cycle completes.
1.
Place the machine on the
3-in-1 Docking Station. Ensure
there is enough solution in the
Clean Water tank to run the
Clean Out Cycle. The level of
the solution should reach the
Clean Out Cycle line. If the
level of solution does not reach
the line, then fill with water to
that line.
4.
Remove the machine from
the dock and wipe out the tray.
Do NOT rinse directly under
faucet. This keeps water out of
the charging plug.

Storing Your Machine

Download the BISSELL Connect App for more useful tips on storing and maintaining
CrossWave Cordless Max.
Store CrossWave® Cordless Max in a protected, dry area. Since this product uses water, it must not
be stored where there is danger of freezing. Freezing will damage internal components and may void
the warranty.
WARNING
electrical outlet before performing maintenance or troubleshooting on the dock.
NOTICE
To reduce the risk of a leaking condition, do not store machine where freezing may occur. Damage to internal
components may result.
10 BISSELL.com
2.
Push the Clean Out Cycle
Button to start the 40-second
cycle. After the cycle is
complete, empty the Dirty
Water Tank. See page 9 for
detailed instructions.
5.
Once the Brush Roll is dry,
place the end of the roll into
the right side of the foot of the
machine. Press the tab of the
Brush Roll down to lock into
place.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
3.
Remove the Brush Roll so
it can dry. Grab the front of
the Brush Roll window and
pull up to remove. Pull up on
the Brush Roll tab to remove.
Put the Brush Roll in the
drying tray. The Brush Roll and
window can be hand washed.
6.
Replace the Brush Roll
Window by lining up the
window tabs with the edges
of the foot. Then, press the
window back into place until
you hear a "click".