Assembling The Heater (Pm10 After Serial #5450 1014 00001) - Mi-T-M Corporation MH-0040-PM10 Mode D'emploi

ASSEMBLY FOR MH-0040-PM10 (AFTER SERIAL # 5450 1014 00001)
ASSEMBLING THE HEATER
Note: Tools required: 7/16" Wrench, 3/8" Open End Wrench, Adjustable opening Wrench 8" long, Phillips screwdriver
1. Attach the wheel assembly with 2x 6mm washers / 2x 6mm lock washers / 2x M6x20 bolts.
2. Attach post to base assembly. Attach the Post to the post mounts using M6 x 20 Bolts (4 pcs). Use flange
cover after tightening bolts.
3. Attach head assembly to post. Load Head Assembly by inserting Gas Hose into Post. Insert Head Assembly
into Post. Tighten securely using M5x12 Bolts (4 pcs).
4. Attach the upper pole to the lower pole by six M4 x 8 bolts.
1.
2.
5. Assembly of reflector. Attach Reflector Cap to top of reflector (4
pcs) using the M6 x 10mm Bolts (12 pcs), 6mm Washers (12 pcs)
and M6 Nuts (12 pcs) as shown.
6. Attach the reflector assembly to top of head assembly, Load the Reflector Assembly to the top of the
Head Assembly using M6 x 10 (3 pcs), 6mm Washers (3 pcs).
5.
10
3.
4.
6.
Propane Patio Heater Manual