Kohler SDMO DIESEL 6500 A XL C5 Manuel D'utilisation Et D'entretien page 20

3.1 Key to illustrations
The cover illustrations can be used to identify the various components of the unit. The procedures in the manual refer to these
illustrations using letters and numbers as identifiers: "A1" refers to the number 1 on figure A.
Earth terminal A1
Battery A2
Dipstick B1
Dipstick upper limit B2
Dipstick lower limit B3
Oil filler cap A10
Fuel level indicator A3
Fuel tank cap A4
Key A5
APM202 A6
Electrical sockets A8
* Source transfer switch, battery charger...
The unit may be equipped with the "GS101-Generator Smart Care" option (A18): the Bluetooth GSC101 box
transmits all the information needed to monitor the unit to an application to be installed on your mobile phone; this
includes maintenance dates, a maintenance aid, and the map of approved resellers for any spare parts required.
3.2 Initial commissioning
On taking delivery and commissioning the unit:
1. Check that it is complete and not damaged in any way.
2. If the unit is fitted with a transport bracket, remove it.
The transport bracket is a metal plate located underneath the engine, close to the earth terminal.
Although useful for transportation, it will prevent optimum operation of the unit (noise, vibration).
To remove it: lift the unit slightly and place it on a block then remove the nut (1) and the clamp (2).
3. Check the oil and fuel levels and top them up if necessary.
4. If necessary, connect the battery, starting with the positive terminal.
Observe the polarity of the battery terminals when connecting it: as this could cause serious damage to the electrical equipment.
Some units require a running-in period. Contact your nearest agent for more information.
3.3 Installing the battery
1. Connect the red wire to the positive battery terminal (+) (A2).
2. Connect the black wire to the negative battery terminal (-).
3.4 Connecting Generator Smart Care
The unit may be equipped with the "GS101-Generator Smart Care" option (A18):
1. Secure the Bluetooth GSC101 box to the unit,
2. Download and install the free Generator Smart Care* application onto a mobile phone or tablet,
3. Create an account,
4. Activate Bluetooth on the phone or tablet,
5. Follow the instructions on the application to pair the phone or the tablet with the Bluetooth GSC101 box.
Generator Smart Care displays all the information needed to monitor the unit in the application; this includes maintenance date
alerts and reminders, a maintenance aid, and the map of approved resellers for any spare parts required.
*Available free from the App Store and Google Play (excluding any connection fees charged by the phone system operator).
Before using the unit, always:
1. Check that the unit is correctly installed and that it is ready to start.
2. Make sure you have understood all of the operating procedures.
To stop the unit in an emergency: turn the key to the "OFF" position and close the fuel tap(s), if fitted.
1085_EN.docx
Stop lever
Oil drain plug
Oil filter
Oil filter screw
Oil filter cover
Fuel filter
Fuel filter mounting clip
Fuel filter mounting clip screw
Air filter
Wheel
Air filter cover
16/254
Section 3. Getting started with the generating set
A9 Wing nut
A16-B4 Paper element
B7 Rubber seal
B5 Exhaust silencer
B6 Circuit breakers
A11 Connections for options*
C1 Operating indicator (APM202)
C2 Fuse holder (APM202)
A12 GSC101-Generator Smart Care
D1
D2
Section 4. Using the generator set
D3
D4
D5
A14
A7
A15
A17
A13
A18
1
2
2020-08-19