Switch Off - Ortovox S1+ Mode D'emploi

S1+
FAULT
If a malfunction or problem is detected during
the self-test, an acoustic warning sounds. The
type of fault and warning code are displayed.
A warning can be triggered by the immediate
proximity to another transmitting avalanche
transceiver, mobile phone, wireless device,
large metal parts or particularly strong
magnetic fields.
If the malfunction warning is displayed during the self-test, then carry
out the test again in the open in surroundings without interference.
When doing so, it is essential to make sure that no other transmitters are
nearby.

SWITCH OFF

wireless devices etc.) or move them well away.
If the warning is displayed again, the device must be sent to the ORTOVOX
service department.
Further information about the service can be found on p. 66
WHAT THE WARNINGS MEAN
E001 Transmitter
E002 Receiver
E003 Transmitter and receiver
44 EN
all SOURCES OF INTERFERENCE
E004 Rotation angle sensor
E005 Rotation angle sensor
E008 Slope sensor
INSTRUCTIONS
OK
(mobile phones,
and transmitter receiver
E001