Microlife WatchBP home S Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4) Automated triple measurement– The WatchBP
Home S automatically takes three consecutive
measurements at 15 second intervals. Because blood
pressure constantly fluctuates, a result determined in
this way is more reliable than one produced by a single
measurement. During the measurement do not move,
cross your legs, or tense your arm muscles. Breath
normally and do not talk.
15 sec.
The last three measurements will be saved for future
*
review. Please refer to page 11 "viewing measurements".
1
2
3
15 sec.
15 sec.
5) Finishing the measurement– Once the three readings
are complete, the measured data is automatically
averaged and displayed.
6) Storing measurement data- WatchBP Home S
automatically stores the average of the 3 consecutive
measurements, along with the date and time. A
total of 30 average measurements can be stored.
When memory is full, each new measurement will
automatically overwrite the earliest measurement.
If one of the individual measurements was questionable, a
*
fourth one would automatically be taken.
* If the start/stop button is pressed during countdown it
will start measuring immediately; if the start/stop button
is pressed during measurement it will terminate the
measurement; the reading or average readings from the
measurements are displayed.
8
EN

Publicité

Table des Matières
loading

Table des Matières