Velleman CAMSCC16 Notice D'emploi page 5

6. Installation
mounting
•
Mount the included mounting bracket on the top or bottom of the camera
using the 2 screws. Note that an additional mounting bracket is required
to fix the camera to the wall or ceiling.
•
Connect the video output [H] to a monitor or other video device via a
75Ω type coaxial cable (not incl.).
•
Mount a lens (not incl.) to the front of the camera.
o When using a C-mount lens, the C/CS adaptor (metal ring) must remain
in place; screw the C-mount lens clockwise into the adaptor.
o When installing a CS-mount lens, use the small hex key to loosen the
hex screws on the top and at the bottom of the C/CS adaptor (do not
remove them completely) and unscrew the adaptor counter clockwise.
Screw the CS mount lens clockwise into the camera body. Do not tighten
the hex screws too hard to avoid damage to the lens or housing.
•
Set the iris Video/DC drive selector [A] to the correct position depending on
the mounted lens type.
•
Connect the auto iris lens connector [B]. Refer to page 2 for the applicable
pin layout.
•
Connect an external keyboard (not incl.) to the serial connector [D]. The
layout of the connector depends on the connected keyboard.
28/05/2009
CAMSCC16
R+ Interface receive+
R- Interface receive-
RS-485
RS-422
T+ Interface transmit+
T- Interface transmit-
5
©Velleman nv