Nice HSRE12 Instructions Pour L'installation page 8

3.6 - Operation in alarm situations
The alarm status can be displayed for a short time only (Dip
Switch N°2 = OFF) or can remain memorised with the relative
"ALL" (Dip Switch N°2 = ON).
Detector alarm
The transmission of a detector alarm causes switching of the
relative output relay as programmed.
Tampering alarm
Opening of the receiver and/or transmission of tampering
with detectors always causes switching of the "Tamper"
relay.
Battery low signal
This signal sent by a detector always causes switching of the
battery relay
Supervision
The lack of supervision signals for more than 8 hours cause
switching of the Supervision relay
Radio disturbance
Continuous disturbance, such as to inhibit correct operation
of the receiver (on both frequencies) cause switching of the
R.F. Noise relay
3.7 - Event signals
• LED: each alarm is signalled by "ALL" output leds, and
therefore can be checked immediately; for example, the
event of a alarm on detector 5, led 5 will start flashing; in
the case of a low battery on the same detector, led 5 and
the battery led will both flash.
6 - English
• BUZZER: with Dip Switch N°3 set to ON, the internal
buzzer indicates activation (3 BEEPS) and deactivation (1
BEEP) when switching between the ON and OFF status
and vice versa. During the ON period, if fault signals occur,
a further 5 BEEPs are emitted.
Attenzione! – Fault signals must never be ignores as they
indicate problems with system operation. In particular, if the
"buzzer" indicating these faults is inhibited, the relative out-
puts must be connected so that signals such as that for the
low battery, tampering, radio disturbance and supervision
failure are indicated on the connected control panel.
4 - MAINTENANCE
HSRE12 does not require special maintenance.
5 - DISPOSAL
As in installation, also at the end of product lifetime, the
scrapping operations must be performed by qualified per-
sonnel.
This product comprises various types of materials, some of
which may be recycled and others must be disposed of;
seek information of the methods of recycling or disposal as
envisaged by local legislation for this product category.
Some product parts may contain pollutant or hazardous
substances; if disposed of these could harm the environ-
ment and personal health.
As indicated by the symbol in the figure, dis-
posal of this product in domestic waste is
strictly prohibited.
Execute the separate collection for the dis-
posal according to the methods envisioned